The 234B-150 TEC TO-Can LaserMount was designed with high power TO-cans in mind… with a maximum laser current of 3A, support for the new 2-pin high power TO-can devices, and capable of handling 10W thermal loads while still maintaining 25°C, the 234B-150 can handle even the most powerful TO-cans you can throw at it.

The 234B-150 is designed for post-mounting (post-mount not included), with 8-32 and M4 threaded holes on the bottom of the mount.

CAGE Support

The 234B-150 cover includes mounting holes for 30mm CAGE systems available from Thorlabs, Linos, and others. For applications that require a 1″ lens tube interface, the 234-C-02 cover plate may be purchased separately.

No Wiring

The 234B-150 requires no wiring to configure it for your device. Instead, there are switches to configure the mount to the wiring of your device. The 234B-150 supports all standard TO-5.6 and TO-9 devices, including high-power 2-pin TO-cans.

High Temperature

The 234B-150 high-temperature configuration, allows for operation up to 150°C, while retaining the temperature range and thermal capacity of the standard mount. Because thermistors do not perform well at high temperatures, the sensor is replaced with a high accuracy Pt 100 RTD sensor. There is an additional cost for the high-temperature configuration, please contact the factory for a quote.

Supports 2-pin High Power Devices

In addition to being a high power mount, the 234B-150 natively supports the newer 2-pin high power TO cans, which operate at up to 3A and can dissipate as much as 8 to 10W of heat. The 234B-150 is the only mount on the market that can handle these high-power lasers.

DB-9 & DB-15 Interfaces

The laser driver and temperature controller connections are made through a DB-9 LDD and a DB-15 TEC connector on the back of the mount, which allows for quick connections to any Arroyo Instruments controllers.

Input connectors

Temperature Control

General